lubricating, help needed.
Moderator: T-man
6 posts
• Page 1 of 1
Hey guys, I noticed today that the bite handle on my Kimura IV was sticking a little bit. So I decided to lubricate it. I lossened the pivot screws a tad and sprayed some Remm oil in them. Now, A few hours latter, I'm noticing that some black gunk is coming out of the pivots. Is this suppose to happen? I hope the Remm oil isn't desinigrating the o rings. Any answers will be helpful thanks.
Re: lubricating, help needed.
There's no O-rings in your kimura. Its just crap coming of your washers.
FaultyPly- "My cocks breaks the glass in your optical lenses while I skull fuck you"
Crockus- "guess Im just used to "small things"
Re: lubricating, help needed.
The title really attracts attention
Re: lubricating, help needed.
GetTheFood11 wrote:The title really attracts attention
hahahaha
6 Out of 18. What are you?
/ Rolling with the cutting edge of a new order.
/ Rolling with the cutting edge of a new order.
Re: lubricating, help needed.
Astroglide...
Could be worse...I could be on the short bus with the other donut punchers.
Well dingalingong my dangalonglinglong.
11th place FAToC 2010!
I got your ass next year cocksmokers!!!
Well dingalingong my dangalonglinglong.
11th place FAToC 2010!
I got your ass next year cocksmokers!!!
Re: lubricating, help needed.
Most of it is excess oil working its way through and out. It's fine.
Me: Check this out.
Grandmother: Stop doing that, you're making me a nervous wreck!
Me: I'm going outside then!
Grandmother: It's too hot!
Grandmother: Stop doing that, you're making me a nervous wreck!
Me: I'm going outside then!
Grandmother: It's too hot!
6 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 99 guests