The Flipping Arena

so iv had my kimura 3 for about 2 months now and the safe handle is getting so loose!! i just took it apart and cleaned and am going to loctite it( which i learned from knifezoids tutorial) thx buddy
but the problem with the safe handle was it was pretty loose and it would move left and right( say if you were holding the knife up and down).... and i think it was because the end of the handle (where the latch meets it) those 2 lil screws are both so loose! there not holding the handle together very well and ive tried tightening them but they dont go anywhere! so i got my blade tooken off of the handles and everythings all clean, im just waiting to get help with those 2 screws before i loctite and put it back together..

Sounds like you may have striped the thread on the screws...... perhaps.

do u know what size torx fits in the ones im talkin bout? its smaller thn the t8 thts connecting the blade to the handles..

I was told that Kershaw(kimura makers) only use t6 and t8

No clue. But I got a set of torx for about $5 from my local hardware store. It had both sizes that were needed for my Kimura.

Pivots = T8
Spacers & latch = T6

thank you guys!!
I LOVE THIS SITE!!