Tue Aug 07, 2012 3:17 pm by Quintocer0s
Get a nail about the size of the hole and cut it a tiny bit longer than needed. I think freezing it helps slide it in easier I'm not entirely sure about that. Then once you get it in, lay the tang pin on something sturdy and take a hammer and hit it a few times to make it bulge. Repeat for the reverse size. If it bulges too much for the knife to lockup properly you'll want to sand the nail a bit to make it uniform. You might be able to use a vise to set the nail instead of using a hammer, I've never done either of these so I wouldn't try it on a knife that wasn't a clone.
edit: this should be in maintenance by the way.