FAQ  •  Czat  •  Register  •  Login

Washers?

Moderator: T-man

<<

terreldactyl

Posts: 18

Joined: Tue Dec 18, 2012 2:41 pm

Post Mon Dec 24, 2012 3:11 pm

Washers?

I bought a pretty good CCC a few days ago but it was used and one of the handle screws came out. I like the way it flips but while im replacing the screws id like to replace the washers too. I see washers made out of teflon, brass, steel, ball bearings and nylon. Which ones should i use to get the smoothest and most reliable flip while staying cost effective?
<<

Wheelman185

User avatar

Posts: 161

Joined: Fri Jun 15, 2012 7:49 pm

Location: Red Raider Country

Post Mon Dec 24, 2012 11:18 pm

Re: Washers?

Pho Bronze! Nylon isn't bad either. Phosphorous Bronze is supposedly one of the slickest materials available that I personally know of.
-Wheel


Just started flipping? Hard to find decent Balis in the $30-$60 range? The Search Ends Here!

Don't hold out for a BM42! Take that $400+ you are planning on spending and go get in line for an Alpha Beast! You won't be disaponted!
<<

vileperson

Posts: 9

Joined: Sat Dec 22, 2012 12:32 pm

Post Wed Dec 26, 2012 10:27 am

Re: Washers?

Yep, phosphor bronze is the way to go.

Buy sets in a couple of different sizes so you can get it just right the first time. If you buy them in bulk, you will get a better price per unit and you will have left overs for upgrading other knives as well.

Return to Modding/Making

Who is online

Users browsing this forum: No registered users and 1 guest